What
is the CCA rating?
The cold cranking ampere (CCA) rating refers to the
number of amperes a battery can support for 30 seconds at a temperature of 0°F
until the battery voltage drops to 1.20 volts per cell, or 7.20 volts for a 12V
battery. Thus, a 12V battery that carries a rating of 600 CCA tells us that the
battery will provide 600 amperes for 30 seconds at 0°F before the voltage falls
to 7.20V.
What
is the marine cranking rating?
The marine cranking ampere (MCA) rating refers to the
number of amperes a battery can support for 30 seconds at a temperature of 32°F
until the battery voltage drops to 1.20 volts per cell, or 7.20 volts for a 12V
battery. Thus, a 12V battery that carries a MCA rating of 600 CCA tells us that
the battery will provide 600 amperes for 30 seconds at 32°F before the voltage
falls to 7.20V.
Note that the MCA
is sometimes referred to as the cranking amperes or CA
Define
the difference between MCA and CCA.
The marine cranking ampere (MCA) rating of a battery is
very similar to the CCA rating; the only difference is that while the CCA is
measured at a temperature of 0°F, the MCA is measured at 32°F. All other
requirements are the same — the ampere draw is for 30 seconds and the end of
discharge voltage in both cases is 1.20 volts per cell.
I
have heard of an HCA rating also. What is it?
The full form of HCA is hot cranking amperes. It
is the same thing as the MCA or the CA or the CCA, except
that the temperature at which the test is conducted is 80°F
What
is the pulse cranking amp rating?
Unlike CCA and MCA the pulse cranking ampere
(PCA)
rating does not have an "official" definition; however, we believe
that for true engine start purposes, a 30 second discharge is unrealistic. With
that in mind, the PCA is a very short duration (typically about 3 seconds) high
rate discharge. Because the discharge is for such a short time, it is more like
a pulse.
Are
these a gel cell? What’s the difference?
No, the ODYSSEY is NOT a gel cell. It is
an absorbed electrolyte type battery, meaning that there is no free acid
inside the battery; all of the acid is kept absorbed in the glass mat separators.
These separators serve to keep the positive and negative plates apart.
The key difference between the gel cell and the
absorbed glass mat (AGM) cell lies in the fact that in the AGM cell all of the
electrolyte is in the separator, whereas in the gel cell the acid is within the
cells in a gel form. In fact, if the ODYSSEY battery were to split open, there
would be no acid spillage!
I
do not understand the Ah rating. Please explain.
The ampere-hour (Ah) rating defines the capacity of a
battery. A typical battery that is rated as a 100Ah battery at the 10 hour rate
of discharge is capable of delivering 10A for 10 hours before the terminal
voltage drops to a standard value such as 1.67 volts per cell, or 10.02 volts
for a 12V battery. Similarly, a 50Ah battery would supply a 5A load for 10
hours. The BP1000 battery is rated at 42Ah, so it can furnish 4.2A for 10 hours.
What
is the reserve capacity rating? What does that mean in the industry?
The reserve capacity of a battery is defined as the
number of minutes that it can support a 25 ampere load at 80°F until its
terminal voltage drops to 1.75 volts per cell or 10.50 volts for a 12V battery.
Thus a 12V battery that has a reserve capacity rating of 100 signifies that it
can be discharged at 25 amps for 100 minutes at 80°F before its voltage drops
to 10.75 volts.
Is
ODYSSEY® a completely dry battery?
Because the ODYSSEY® has no free acid inside the
battery, it is covered under the US Department of Transportation (USDOT)
unregulated "wet nonspillable wet electric storage batteries"
classification and International Air Transport Association (IATA)
"unrestricted" air shipments categories. These batteries may be
shipped completely worry-free.
You
mentioned high impedance. What is it?
The impedance of a battery is a measure of how easily it
can be discharged. The lower the impedance the easier it is to discharge the
battery. The impedance of the ODYSSEY battery is considerably less than that of
a marine battery, so its high rate discharge capability is significantly higher
than that of a marine battery.
How
much current is generated if I accidentally short this battery?
As suggested before, the ODYSSEY battery is a very low
impedance product, meaning that the short circuit current can be extremely high.
For a series system (24V), the short circuit current will be of the order of
2,500 amperes; a 12V parallel system will generate close to 5,000 amperes!
Do
I ruin the battery if I accidentally drop it? Does it void the warranty?
Not necessarily, but it is possible to damage the
internal connections sufficiently to render the battery useless. Our warranty
applies only to manufacturing defects and workmanship issues; the policy does
not cover damages suffered due to product mishandling.
What
is so special about pure lead tin technology? Is it a new technology?
While the answer to the first part of the question
requires a detailed response, the short answer is that the extremely high purity
(99.99%) of our raw materials makes our product very special. The technology is
not new; the sealed lead recombinant technology was invented and patented by us
back in 1973.
How
come you don’t have to winterize your batteries? What’s so special about it?
In general, winterizing strictly refers to a special
maintenance procedure conducted on an automobile engine to insure its
reliability during the coming winter season. This procedure essentially checks
the engine’s cooling system; in addition, the battery is load tested according
to a specific protocol laid out by the Battery Council International (BCI).
While ODYSSEY batteries do not specifically require this test to be conducted on
them, the final decision whether or not to conduct this test is left to the
user’s discretion.
Are
these Ni-Cd batteries? Why doesn’t somebody make these in Ni-Cd? Wouldn’t
they charge faster with Ni-Cd?
No, the ODYSSEY is NOT a
Ni-Cd battery; it
is an absorbed (starved) electrolyte sealed lead battery. In general, nickel
cadmium batteries are much more expensive to manufacture and recycle, so they
are far less cost effective than a lead acid product.
A nickel cadmium battery would charge faster
than a conventional lead acid battery; however, the ODYSSEY is NOT
a conventional battery and its charge characteristics are somewhat similar to
nickel cadmium batteries. In fact, with a powerful enough charger, it is
possible to bring ODYSSEY batteries to better than 95% state of charge in under
20 minutes! That is very comparable to the fast charge capabilities of a nickel
cadmium product.
|